Just picked up a 76mm precision what should i do

you would need a lot of fuel.

Like nozzles and everything. Ive got a sump kit and lift pump going on with the cac pipe and elbow but thats

maybe do a bit of reading, with proper fuel and tuning along with supporting mods that turbo has done over 800.

Jbird said:

Ive got less then 700 in the turbo what could i get for it you think

Click to expand...

That Would depend greatly on witch model it is.

If is a journal bearing or the ball bearing 76.

I know when I looked into buying a new precision turbo their journal bearing versions were a fair amount cheaper.

your sump and lift pump honestly dont help much..

you need dual fuelers and a minimum of 60's to remotely drive that charger like it should i would imagine.

flip it and buy a whole set of stock location chargers or atmo upgrade.

if you go that route and are intererested in barder charger setups let me know

I saw that turbo on eBay also, to me it looked like a 42 off a detroit with a precision turbine housing.

It wasnt on ebay. But alright guys thanks for the help

Jbird said:

It wasnt on ebay. But alright guys thanks for the help

Click to expand...

Then the exact same one was. But yea it's nothing special man. I Would do what the others have suggested

Well i wasnt wanted to run a smaller single anyways. So i guess ill keep stocking up on all the supporting mods for something like a s366. And maybe that check uncle sam sends me at the first of every year to actually put it all in