6.4 2.6 pulling truck build

Joined
Oct 1, 2012
Messages
5,868
Reaction score
0
Location
Athens, IL
You're twisting off 300m shafts?

No, not with the setup I have now listed above.

I did break the 4340 rear shaft. Then I went to the 300m in the rear. They are twisted but not broke.

The fronts were stock. Now they are 4340 with billet u-joints and stock stub shafts.



Lots of parts break. That's how you know your putting power to the ground... you break stuff without hopping to do it.
 

B585Ford

New member
Joined
Mar 17, 2012
Messages
2,730
Reaction score
0
Location
WV
This is a Dynatrac Pro 80, not a tiny factory sterling. Dont have to do any of that. This axle was built to withstand anything you can throw at it

Im actually shearing the shafts off, not twisting the housing up.

I have a little deal with Dynatrac that if I destroy their parts, they build me something stronger, well.. I sent them a PO for 2 new stronger sets of shafts today.

And to think.. when I said I wanted an extra set they laughed at me..

I could ***k up an anvil in sand :naughty:

Congrats....obviously you gotta be hooking with some serious power to do that.
 
Joined
Oct 1, 2012
Messages
5,868
Reaction score
0
Location
Athens, IL
gyvarubu.jpg

7u7edaje.jpg

aqupepyt.jpg


Shots from Saturday.
 

ford rules

New member
Joined
Oct 15, 2012
Messages
1,392
Reaction score
1
Did I see you say on one of the facebook vids that the truck is down on compression?
Thing still looks like its running great!!
 

Latest posts

Members online

Top