drunk on diesel
New member
- Joined
- Sep 7, 2011
- Messages
- 4,179
- Reaction score
- 0
plan was blue loctite and ~15-20% over OEM torque spec on the short bolts
TIA for any input
TIA for any input
ported intake bolt torque?
- Thread starter drunk on diesel
- Start date
footlong70
New member
Oem torque is 100in/lb
powerstroked08
Active member
I did blue loctite and 10 ft lbs.
Sent from my GT-I9192 using Tapatalk
Sent from my GT-I9192 using Tapatalk
NathannialD
New member
I see no reason to loctight them, I usually do 10-12' lbs depending on the truck
powerstroked08
Active member
I only loctite them for that "god forbid", one comes loose and goes through the motor.
PrecisionEngine
Member
I'm going to installing one of these intakes soon, can you not stake the bolts ?
drunk on diesel
New member
- Joined
- Sep 7, 2011
- Messages
- 4,179
- Reaction score
- 0
Yeah, in retrospect, no "need" for locker, it's precautionary.
Oh, and don't go too tight on that rear frost plug that doesn't look quite seated enough
Oh, and don't go too tight on that rear frost plug that doesn't look quite seated enough
