Cable works good. His end that plugs into black maxx is alot looser than my cable end. Does what it is suppose to do though.
Sent from my SM-N920V using Tapatalk
It will be alot easier to get the pin layout this way. Cables should only be about 50. But you know some people are greedy.
Sent from my SM-N920V using Tapatalk
http://www.ebay.com/itm/H-S-Black-Maxx-or-Bully-Dog-PMT-Tuner-Power-Cable-/262712561851?hash=item3d2ae390bb:g:jFoAAOSwal5YI4tV&vxp=mtr
Yikes, kinda spendy. Same idea I had.
Just an update. I have the power and ground figured out. I don't have the other accessories like pyro and such so won't be able to map those out, but should have the can bus high and low figured out this week if work doesn't get in the way.
Sent from my SM-N920V using Tapatalk
4 screws on back and carefully peel top and bottom cover off. Careful it is very thin metal. Held on by 2 sided tape
Sent from my SM-N920V using Tapatalk
Well, made some progress today. Plug turns out to be a variant of the dfp20 male plug. Just trimmed the outer shell off and she fit tight into the unit. Just have to wire the convert over to hdmi now.
Sent from my SM-N920V using Tapatalk
Well, got my dfp cables today and it wasn't that connector either. I was sure it was that. Must be a proprietary plug. I would have never guessed that.
Alex
I believe the connector for the bottom port is a dfp20. I got a cable ordered to try that connector. If that doesn't work I'll just solder on 4 wires to the board and go from there. If anyone has a used cradle in not working condition it would be very helpful even just to borrow.
Sent from my...
So, I tried to wire straight from the mini-usb to hdmi. That didn't work and got a communication error. My guess is because it is looking for communication through the bottom port. I'll continue my trial and error till I get it sorted out.