Recent content by NMartin

UPDATE: I installed a new Motorcraft uvch, new old engine loom from a running part out and had the injectors sent back to Swamps for warranty inspection. I added a new ground from the ground block at the starter to the frame and cleaned all ground contacts under the hood. So far, it is back...

I ohm checked the harness at the idm plug with everything hooked up, except the idm. I am getting 2.8 ohms at each connection with open lines on the grounds. When I put the Dorman in last winter, I did replace a plug on the under hood harness but it is on cylinders 6 and 8.

I'm not showing any codes with the computer scanner.

I'm not getting any codes to my knowledge.

I also run l.e.d lights all the way around the truck. Again, just trying to include all details.

My truck is a 1997 2wd F350 7.3. E fuel, Baby Swamp injectors, cx racing intercooler, 6637 filter, hydra chip with custom tunes, hx cross over line, 4" exhaust, rebuilt turbo with 360° bearing and 7 fun billet wheel, heat wrapped up pipes and down pipe, IssPro gauges.....I know these things may...

I'm frying IDM modules and need help. I've fried 5 while trying to figure it out. Ohm testing hasn't shown any issues. Alternator tested ok, many inspections have left me scratching my head. What an i missing? Anybody else have this issue before?