Search results

Hello again, I broke another damn flexplate.. Mikes diesel replaced the last one and it lasted about 9 months. The flexplate is still under warranty but the work is not. I did some research and the crankshaft spacer is different for manual to auto. The engine I put in had manual pins (1st/2nd...

I tore down my engine block that the number 8 cylinder wall cracked on. Don't much care what I get for anything l, just don't want to scrap parts someone may need. Crankshaft 50$, camshaft 50$, lifters 10$, timing cover 25$, water pump 25$, 15°hpop with about 2000 miles on it 75$, new obs...

I'm getting a slight vibration while driving, gets worse under a load and making hard turns. Hubs and u joints on front end are new. It's starting to pop out of 4 wheel low and makes a loud bang when it does. When I turn it makes a pop/clunking noise. I just serviced the front differential...

I need one... Thanks Sent from my E6782 using Tapatalk

I need to find a reputable mechanic in my area. Sooner the better. Thanks Sent from my E6782 using Tapatalk

This morning when I started my truck it cranked right up but died immediately. Took 6/8 tries to get it to idle. it burped up and then would go to about 400rpms try to get up again and die. It was very quick though. Once she idled all seemed well. On the road she hissed and screeched kinda...

I just installed a new engine. Everything is working great except my alternator and the temp guage on my dash... I charged the battery's and tested them they are good. Tested the alternator and the battery's while the engine was running and they are not charging. replaced alternator. Still not...

I bought a new, never fired 7.3l DI for my 2001 f250. It's already installed and with the transfer of a few plugs and my injector harness and turbo, fuel bowl, and a few other things I'm ready to go. Just waiting on my pcm to get back this week. It has the AC injectors btw. Does anyone see...

I'm looking to sell my injectors and heads off my 2001 f250. Replaced the engine and it came with new injectors so I don't need these. The block is cracked so I don't have that. I also have the hpop but I took the sensor plug in off of it that goes to the exhaust manifold so you would need that...

Hello all, Firstly thanks for all of them information everyone has shared on here, has been incredibly useful over the last couple of years. Just got around to joining. I blew a rod t 234,000 and replaced the engine with a crate motor that came with new AC injectors. After I got it installed...