Search results

Should my AC pump be cycling on and off fairly constantly, even while the heater is on? It would make sense when using AC, but not heater

I read on here some place where a guy was talking about being able to lock his converter with a toggle switch. Can a guy explain how to do this? It would be nice to be able to do it while towing. Thanks.

Can anyone give a break down of the wires going in to my fan? There's a plug at the top of the radiator. I'm installing an electric fan kit with a controller. The controller wires directly to the battery but has several probes on it to turn the fans on several different ways. My stock fan is set...

What fluid y'all running in your built transmissions? Just got my Elite stage 4 with tow upgrade in and am ready to fill with oil. In 08 Ford ran the LV? Then switched to SP? In 09.. I may be backwards on that but you get the idea.. Not sure which to go with and of course Elite is closed today.

What temps and pressures would the computer defuel a factory engine?

Hey guys, what's the real honest truth here? I know a lot of guys upgrade there's, I don't think its a bad idea. I've done about all the mods I can to maxx out on stock fuel. My low system has 147k miles on it, HP pump is brand new. I change fuel filters every oil change at 5,000 miles. Rotella...

Anyone ditching there fan for a couple electric units? Looking at the tuning files in MCC I noticed the fan doesn't even kick on till a coolant temp of 212. I never tow hard enough to get that warm.. Any thoughts?

Anybody running there kit? Ive done the re route but the factory fill can is ugly. The MPD kit looks nice but my concern is that its so short ide be worried about it pushing oil out with the air since its so close to the rocker cover. Any feedback before I order? As usual, Thanks!:ford:

I'm about to order a Trans. I'm thinking an Elite stage 4 with deep pan and tow upgrade. Already have a converter. Is there another company I should consider, or buy the Elite? Thanks.

Gunna pull the trigger on an Elite stage 4, 5R here shortly. I've got the RCD triple disk in there now, should I do a billet flex plate while I'm in there, or is it a slim chance the stock one will fail? Thanks fellas.

6" lift, 36/1250/24s brand new steering pump today, after it's warned up it still won't turn lock to lock while parked. ATF in for oil.. Am I asking to much? Is there a better fluid? Thanks..

Haven't confirmed yet, but I think my new oil leak might be a turbo drain. Just did everything from the heads up, including a stage 2 intake manifold. One thing the mechanic helping me out noticed the new manifold didn't have the bolt studs sticking up like the factory manifold so the turbo...

Hey guys, stock Trans, Gearhead tuning. over night it started having a delay when I shift in to reverse. With that delay there is a bit of a shutter that rocks the truck slightly as it goes in to gear.backs up fine once in gear. Oil and filter was done at Ford last summer. Any thoughts? Thank you!

So a friend of mine mentioned this waterless coolant to me from Evans. They claim it lasts forever, will not corrode and will not cavitate. It also uses a vented coolant cap so the system runs at 0 psi. For us 6.4 guys this coolant should mean no more rad blow outs, no more holes in the front...

I asked all of you for your opinions about replacing my HPFP while I was in and I was told to do so. Seems when they fail it usually cost a guy the motor. Question is, what does a guy do to keep it from failing? I've herd some guys say just monitor rail pressure and if it doesn't maintain like...

If um looking at the instructions correctly I'm thinking if the truck makes less than 30psi boost I need to leave the softer spring in the valve and if over 30 psi, I need to install the heavier spring. Does this sound right?

Hey guys, so I ordered a head stud/gasket kit from a company. I was told the gaskets were OEM. My Buddy installed and torqued the heads down today while I was gone. When I got back he told me the gaskets were black instead of blue like the OEM Ford ones. Would these be the black onyx deals? I'm...

Hey guys, Looking for tire ideas in the 35" ish tall tire that will look good on a 14" wide wheel by 24" tall. Hard to find a tire in that size... Any pics on here of a 12.50 or 13.50 on a 14 wide? Wondering what can be ran that will still look good. a 35 15 24 would be the best option but may...

Getting ready to replace about everything from the heads up. A buddy said I should replace the HPFP while im in there. He says they commonly fail and take out injectors and such. I haven't had a chance to monitor RP but as far as I know, everythings been fine there. 145k on the odo. Should I...

I've got the 72 on the low side already. Since I'm going in, wondering if I should do something on the hi side also. Looking at Elites site it seems there tow power 59 would be the match to my 72. They also have the bat wheel.. sticking with stock fuel.. would it be worth my investment, or...