Search results

I have a set of 2in. Wheel spacers and broke a stud off, I can't seem to find a wheel stud anywhere to fit. Does anybody have these, and know of any replacement part numbers.

This is a set of used elite diesel stock high efficiency 8-hole nozzles. They have about 10,000 miles on them.

I have a 6.0 intake that was ported and polished, and the coolant section removed from intake, that is welded back together. The rear of intake is slightly warped, and needs to be spread with pry bar when installing. Must have removed from jig to soon after welding. Or will trade for 2 used old...

Hey guys what are the dyno numbers on the 2011-14 with a cold air intake and a friendly tune with emissions on. And which tunes are you runing. Thanks

We had 2 turbos stolen or lost at UPS, they were MTW stage 2 and stage 3, going back to Adrian for further mods, from Indiana to Mississippi and were stolen at the Mississippi location. Please be aware of anybody trying to sell these turbos. Thank You from PowerStroke Connection.

We had 2 turbos stolen or lost at UPS, they were MTW stage 2 and stage 3, going back to Adrain for further mods, from Indiana to Mississippi and were stolen at the Mississippi location. Please be aware of anybody trying to sell these turbos. Thank You from PowerStroke Connection.

Does anybody know if there is anything out there available for the 6.0 , as far as a hi output low pressure pump. Thanks

Has anyone heard of several different trucks this past weekend that have dynoed over 500hp with stock injectors and with an aftermarket turbo?

Has anybody put down 500 plus hp on stock injectors yet?

Just got my Hybrid installed from Adrian, I was running a PowerMax with a batmowheel. All I can say is Holy Cow, this is a completely different truck. Spool up is instant. EGT are 100 to 200 degrees lower. I have a modified Y-pipe, Intake, and injectors to do also. But I'm doing them and stages...

Big Thanks goes out to Mike at KEM Performance, who stopped by the shop today to tune a couple of trucks and tweak on a few others. One of the customers has already gotten a speeding ticket. Looking forward to getting some numbers on your race truck. See ya soon. Dan

Does anybody know if there is a 5-piece stainless steel braided brake hoses available for 99 to 04 superduty in stock lengths. Thanks

Looking for 2 tone or reluctor rings for crankshaft. PM with message. Thanks

What do you guys think of our project truck. 2001 CC LB , hopefully 1 of 1. As far as we know these were only made in SB trim, but I could be wrong.

We just got a call from Bullseye yesterday, our tow compounds are there and the 71mm batmowheel is on, and should have the 59mm batmowheel done next week. Then the 59mm should be availible soon, if anybody is interested.