Search results

Any suggestions? Shes tired. Was looking At Twisted and a few others. No mods other than the usual. IDP street daily. She don’t get driven hard anymore and occasional pulling. Max 8k

Thanks! I ended up ordering the FASS 140. I’ll shim the spring if I need to. Thanks for the heads up. Sent from my iPhone using Tapatalk

Good morning all, currently been having several issues from my current setup which is an old legacy series FASS lift pump going into an aeromotive high pressure pump up to the regulated return. Wanting to ditch that system and go with one central unit capable of 55psi or so. Any suggestions? Thanks!

Anyone have any that are in semi decent shape?

Currently have a sump, to an old school FASS red base pump, pushing to an aeromotive pump, then through a big CAT filter, and then to the regulated return setup. I need to replaced some old fuel lines this week and do y’all think I’ll be ok with doing away with that CAT filter after the...

Thank you sir!

When replacing the valve cover gasket, what else has to be replaced with it? Any injector O-rings or tubes too?

Thanks guys

Right on! I'll look into that. Thank ya sir.

Ok I guess that solves that. Is there any way better than a typical coolant filter to keep them clear? Maybe backflushing every 6 months or so? The truck has always had a coolant filter but it seems like that prolongs the eventual issue rather than prevents it.

About to dive into my 04.5 for injector re-seal, oil rail rebuild , ficm and a few other things. Also considering the high flow oil.cooler from Rudy's. Anyone use it yet? Is there anything else I should consider that anyone has found to be a long term issue while I'm in there or is it just the...

About to dive into my 04.5 for injector re-seal, oil rail rebuild , ficm and a few other things. Also considering the high flow oil.cooler from Rudy's. Anyone use it yet? Is there anything else I should consider that anyone has found to be a long term issue while I'm in there or is it just the...

So in yalls experience, what's the thoughts on Rotella ELC as a replacement?

Does anyone know if this is correct from the factory? Did it change? About to take some things off this engine and just wondering if its correct. I couldn't find much online. Thanks

Hope I'm not beating a dead horse as I haven't been on here in a while. I recently had oil temp of 225ish while towing around 6k with my 2012 and the truck cut the power in half from the temp threshold from what I was told. I've heard that the problem is a faulty oil valve in the pan restricting...

2012. Full deeletes, has random loping at idle. Clears, then comes back at random times. Any ideas? By my gauges, it idles at 55-5800 rail pressure but as it warms up to operating temp, it idles at 4100 ish.

I guess everyone else is as stumped as me

Ok, installed high pressure Fuelab pump 40401on existing base of the velocity 200gph system, 75micron pre-filter backed to it, outlet fuel ran to regulator, through regulator to inlet of topside HS filter base. Return from regulator ran down and T'D to the return on the filter base which goes...

Will the 2015-2016 e-gee-r block work on 2017?

Got a fuel lab setup halfass on. Wondering about the factory return. From what I'm looking at, does the factory pump push fuel to the filter and return back? I have the return from the fuelab hooked up but now wondering what you guys are doing for the upstream return?