Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
New showcase items
New showcase comments
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Showcase
New items
New comments
Latest content
Latest reviews
Latest updates
Search showcase
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Power Strokes
6.4 Tech
6.4 after rebuild will not run
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="Able, post: 1549862, member: 33244"] Hello everyone, I came across this forum after researching my 2008 F250 6.4 after our rebuild will not run. Any help or suggestions would be great we are back up against a wall on this one: Just to give you some history on this truck, we completely rebuilt the engine. Got it all back together, loaded tune, bled the fuel system and seemed to be running fine. drove out the drive to go on a test run and while driving down the drive when it shifted from 1st to 2nd it shut down. Drug it back to the shop and it had a code of lost communication with TCM. Troubleshoot that code and replaced TCM. Cleared codes and tried to start and would not start. It would crank fine and building fuel pressure but not fire the injectors. Starting checking CAN circuit wires and checking ECM. The truck started while we were checking systems and ran. Checked everything over and went for a test drive. Drove about 4 miles down the road and turned around. Everything was looking good, EGT was around 625-650 at 60MPH. was driving on a straight away and the engine shut down. Pulled back to the shop and started going through the wiring harness. Checked all plugs and CAN circuits between modules. Had batteries disconnected for entire time working on this. After checking all this I did an all system DTC scan. it came up with, did not read Instrument cluster, test manually. Went to TCM and did a scan and said , did not read Eng PCM, test manually, did not read Instrument Cluster. Went to Instrument and did a scan , It had a code B2A20 ING Stuck in start which i could not clear. it also said did not read Eng PCM. and a code B106E solid state driver disable due to short. When i did a scan from OBD II it said Did not read Eng. PCM , test manually. The truck was running when it came to the shop, i cant figure out what is going on. something in the computer isn't happy just cant nail it down. we have done same thing to other trucks ,Fords, Chevys, Dodges and have not ran into this. I don't want to start swaping parts just to swap parts. i want to figure out what happened. All help would be very much appreciated. Thanks.. Able [/QUOTE]
Insert quotes…
Verification
Post reply
Random media
Latest posts
04 ex w/low hpop pressure
Latest: gwunter
Wednesday at 5:47 PM
6.0 Tech
7.3 lift
Latest: Charles
Tuesday at 1:20 PM
7.3 Aftermarket
02 F250
Latest: ToMang07
Tuesday at 8:05 AM
7.3 Tech & FAQ
Heui Injection
Latest: Blowby
Monday at 12:07 PM
7.3 Aftermarket
6.4L Ring End Gap
Latest: ncollins64
May 30, 2024
6.4 Aftermarket
Members online
bismic
Forums
Power Strokes
6.4 Tech
6.4 after rebuild will not run
Top