Search results

Well our family is getting to big for our B4V, and the Excursion is gone now (no more car payements!). So I was browsing craigslist and happened upon an Exploder with a bad head gasket, and no trans/transfer case (auto/auto sensing transfer case). So I got permission from the wife, and $400...

2 factory fog lights. $30 shipped Stock FICM power supply, core (45V cold starts). $50 shipped 4 ZD-13 Motorcraft glow plugs, drivers side GP harness (from ebay, probably chinese, and harness removal tool. $40 shipped

These are an extra set I had. I bought the kit used from another guy, who had it installed but never ran it. He took everything off. So what I'm saying is these were installed at one point, but never actually had oil flow through them. One of the ends needs a little clean up, see in the...

Found a coolant leak on my parents 08 today. This hose needs replaced, but I need a part number. I'm thinking its 8C3Z9F466C but not positive. I would tell them to do an EGR delete but they aren't the kind of people to do that.

Maybe someone wants this? I can palletize it and ship it if needed. About it, its a 7kw generator. Powered by a Kubota D905e 3 cylinder diesel. Output is 120v (58.3 amps), and 6 amps at 12 volts. It came out a totaled 1997 Beaver motorhome, and has been sitting in the wrecked frame for about 3...

DAMNIT!!! Driving yesterday about 3 miles from home...just died, no coughs sputters or anything, just like the key was turned off. Luckily coasted into a church parking lot, and no traffic to boot. Read the CTS codes, FICM supply voltage low. So we get a rid home from my sister. I went back...

I am almost positive that the check ball (some call it a ball bearing) that is in the side of the HPOP has found its way out. Lost power, and now at a hot idle the oil pressure gauge (if you can call it that) registered naught at idle, meaning less than 8psi. Anyways, so I'm going to pull the...

SRL Tune, its a fun tune no doubt. But, this last tank I have driven it roughly the same as before. Now the Ex is getting city driven a lot lately, the last few fill ups (pre-tune) were in the 13.5-14mpg range. Todays fillup was 11.7mpg. Lots of stop and go, but the same style driving in the...

Truck was up to temp, and as I pulled into where I was going I thought I heard the engine surging at idle. Very faint, like +-25 rpm's from idle. Thought it was odd, so as I pulled it I came to a stop, and still heard it (more like I could hear the humming of the accesories belt going up and...

I need a shift indicator assembly (or just the cable part of it, as mine is snapped) for a 2004 Excursion 6.0. I have a part number: F81Z7A110CA, but it appears that is only for 99-03 trucks as its for the 4R100 tranny (PNRD21, mine needs to be PNRD321). Thanks, Justin

I have an inferred EBP statedgy. The first time I loaded this PID, it didnt read anything which I thought was because of the stratedgy. Well, a few days ago I went and loaded it back up...and it started reading? At idle it was reading roughly 37psi, and during acceleration peaked at 70psi. Even...

Been on my shelf for way to long. I have a Amsoil Single Filter Bypass Kit (Amsoil BMK21 Retail $191), and a single Amsoil Filter (Amsoil EABP100 Retail $41.40). To make it work with a 6.0 without any serious modifications it would needs an Amsoil BK1101 - Aluminum Oil Filter Cap (retail...

I'm 90% sure the previous owner ran the exhaust before the rear tire. So the exhaust is cut off after the muffler (which is something aftermarket, dont know what). I think he just cut his tip off. Anyways, I would like to get the over the axle tailpipe section in 4" and then piece it together...

The wife sent me some texts this morning telling me the excursion was white smoking. After it started (no stiction, outside temp 55-60*) she started driving. Said she got about half a block and noticed it was putting out a lot of white smoke, enough that it came and went up and past the front...

After a long drive at freeway speeds (over an hour) my excursion has a rough idle. All fluids are fine, temperatures are fine, FICM was just rebuilt by Ed (with proper voltage). Everything appears to be fine, except after a long drive on the freeway. Basically I will pull off, and the truck...

Seems like a lot of forums are going to chit these days, heard this was an oasis so I decided to join up! I'm Justin, living in SW Houston right now, moving back to the NW in the next year. Own 4 diesel's. 1985 F250 6.9/T19 4x4. Gauges, ATS turbo, straight pipe. Bed needs repainted due to a...