One piece drive shaft? Yes or no?

hunterER7

New member
Joined
Mar 9, 2015
Messages
131
Reaction score
0
What's up guys. Quick question, right now I have the driveshafts out of my truck. I have to replace the Ujoints and carrier bearing in an 07 ccsb lifted around 10-12". My question is. Can I go to a 1 piece shaft without issues? Has anyone done this or can give any insight on this subject? Reason I'm asking is essentially that would remove the carrier bearing and 1 less yoke connection. Would just go from transfer case to axle.

Let me know what you guys think.


Sent from my iPhone using Tapatalk
 

slowcoupe

Member
Joined
Feb 17, 2012
Messages
838
Reaction score
0
Location
Las Vegas, NV
Take some measurements and give your shop a call and they'll tell you yes or no. I've seen a lot of guys runs one pieces on CCSB trucks. Longbed the shaft length it just too long.
 

hunterER7

New member
Joined
Mar 9, 2015
Messages
131
Reaction score
0

08Monster

New member
Joined
Sep 8, 2013
Messages
1,871
Reaction score
0
Why would CCLB stop you from going to a single?


Sent from my iPhone using Tapatalk
Too long of a single shaft doesn't have the strength it needs. That's why semis can't run a single.

Sent from my XT1585 using Tapatalk
 

Latest posts

Members online

Top