Tree Trimmer
New member
- Joined
- May 22, 2011
- Messages
- 2,016
- Reaction score
- 0
anyone reading this, bear with me, as im typing and uploading pics as i go.
so i was bored today, and decided to replace my blend doors, as they were clicking, and really annoying me.
the one in the dash was time consuming, but easily changed.
the one under the dash was pretty quick, but a royal pita.
the one by the go pedal was just easy and quick.
so.
pics 1 and 2
under the power point on the left, and under the sync on the right, is two slots. stick a regular screw driver in there, and pry them gently out. disconnect wires, and set them on the dash, out of the way.
this gets you to pic 3, and the center panel.
i drew two arrows at the two screws that need removed. after removing them, its just held in with push-clips. pull the bottom out first, then work your way to the top. it looks like it will break, but it wont. after doing all the clips around the edges, i was left with the ones right over the radio. i slid a screw driver up alongside the radio and gently pryed out.
pic 4 is just the radio. remove the 4 screws, and gently pull out. unhook the wires and antenna, and set the radio out of the way.
so i was bored today, and decided to replace my blend doors, as they were clicking, and really annoying me.
the one in the dash was time consuming, but easily changed.
the one under the dash was pretty quick, but a royal pita.
the one by the go pedal was just easy and quick.
so.
pics 1 and 2
under the power point on the left, and under the sync on the right, is two slots. stick a regular screw driver in there, and pry them gently out. disconnect wires, and set them on the dash, out of the way.
this gets you to pic 3, and the center panel.
i drew two arrows at the two screws that need removed. after removing them, its just held in with push-clips. pull the bottom out first, then work your way to the top. it looks like it will break, but it wont. after doing all the clips around the edges, i was left with the ones right over the radio. i slid a screw driver up alongside the radio and gently pryed out.
pic 4 is just the radio. remove the 4 screws, and gently pull out. unhook the wires and antenna, and set the radio out of the way.