Search results

Sold. Thanks.

Inside bottom door edge. Sorry for multiple posts, can't upload more than one at a time from my phone for some reason.

Rear of driver door

Driver seat

Front of driver door

Pic

$13.5k obo

Bump'n it up.

To The Top

Weekly bump. She runs nice, been using it as my weekend grocery getter. Someone needs this.

Still available

Bump, and a price adjustment. Guess I was asking too much. $14,000 obo

More

$15k obo

2004 Ford Excursion, Eddie Bauer with 6.0L. This excursion is 2WD. 173,000 miles. $15,500. Toreador Red with bronze/gold two tone paint, and two tone tan leather interior. Bench second row seating. Fully bulletproofed at Marty’s Diesel including: New Ford HG's, ARP head studs, new HPOP...

diesel fuel smell or diesel exhaust smell? If exhaust, check the up pipe bellows for cracks like the other guys said. If fuel smell, check the cover on your fuel regulator (next to the fuel filter bowl), it is likely that the o ring is shot and has a minor leak. It may not even be enough to...

I put a Banks monster turbo-back on my excursion and love it. I wanted a free-er flowing exhaust but didn't want additional noise as this is my family hauler. It is well built, fits nicely and is nice and quiet. I kept my cat, and swapped my S&B intake out for stock, and the truck is now a...

I just put a new set of Monroe Reflex's on mine. I read about the custom valved bilsteins, I think those might be worth a try (if I was going to do it over again). The ride isn't bad with the Monroes by any means, just a little jarring over the really bumpy roads. I also have rear airbags, so...

They don't have the LATCH system but the do have the rear anchor points for the tether. I was a bit disappointed in lack of LATCH at first but it is almost as quick to install infant/child seats using a belt and it is supposedly just as safe. I had my Ex bulletproofed (actually...

As always, good vid. I just did one of these seals this weekend. Tossed the seal in hot water, then cut out approximately2"x2" piece of flexible plastic out of a blueberry container, rolled it into a slight cone with one end big enough to go over the threads on the fitting, and the o ring slid...