Strokin6.4
New member
- Joined
- Apr 19, 2012
- Messages
- 1,117
- Reaction score
- 0
Just to make it clear IH is still produced stock bore piston correct? Just not over bored.
Sent from my SCH-I535 using Tapatalk 2
Sent from my SCH-I535 using Tapatalk 2
Or wait just a little bit longer, we're so close
With IH 0.020" over? Or rcd forged?
Sounds like someone's got some pull
That's good to hear, it can be a more affordable option for the poor guys splitting factory pistons. :thumbup:
Thats the end goal! Everyone needs an affordable option thats readily available and cheaper than machining factory .020s
For anyone that wanted to know. International refused to do the .020 over because they said that in their honest opinion going that far overbore on a 6.4 (Maxxforce 7 in their circumstance) would compromise the cylinder walls integrity.Jared
Thats the end goal! Everyone needs an affordable option thats readily available and cheaper than machining factory .020s
For anyone that wanted to know. International refused to do the .020 over because they said that in their honest opinion going that far overbore on a 6.4 (Maxxforce 7 in their circumstance) would compromise the cylinder walls integrity.
Jared
So how much compromise is there when overbored?