Fabtech 6inch icon springs

[Clayjeans]

Does anybody know if I can run the 7 inch icon springs with a 6 inch fabtech?


Sent from my iPhone using Tapatalk

 

[MEDIC350]

Does anybody know if I can run the 7 inch icon springs with a 6 inch fabtech?


Sent from my iPhone using Tapatalk

If you have the fabtech 4 link I don't see why not. There's an alignment bolt on the bottom arm to adjust from 6"-8" lift

 

[josh@thedieselcartel]

Yes that will work just fine.

Do you need a set of springs? I can get you hooked up with springs and or anything else you need.

 

[VetteD_SiN]

could i run a 7" icon spring with the upgraded f350 block that came with my lift on 6" procomp stage 2 setup with foxes? i dont have a 4 link. i have the upgraded radius arm setup. or just leave it as that height? lol. my 22x14 forces should be here any day now.

 

[josh@thedieselcartel]

could i run a 7" icon spring with the upgraded f350 block that came with my lift on 6" procomp stage 2 setup with foxes? i dont have a 4 link. i have the upgraded radius arm setup. or just leave it as that height? lol. my 22x14 forces should be here any day now.

That setup will work. But if your running 22x14s I hope your running 35s. 37s aren't going to clear.

 

[VetteD_SiN]

inmotionjosh: i really wanted to go with 37s. but been hearing a lot of chatter on it not clearing. now im looking into 35s; either 35/12.50/22 or 325/50/22.

 

[josh@thedieselcartel]

inmotionjosh: i really wanted to go with 37s. but been hearing a lot of chatter on it not clearing. now im looking into 35s; either 35/12.50/22 or 325/50/22.

Smart, those two tires will clear just fine.