zilla68
New member
I think I saw somewhere that when you remove the fuel bowl (doing efuel) there is a wire that is no longer used that is a keyed on switch to activate my new pump set up.
any ideas which one it is
any ideas which one it is
key on switched source under hood
- Thread starter zilla68
- Start date
Greger96obs
New member
- Joined
- Aug 24, 2011
- Messages
- 26
- Reaction score
- 0
Fuel heater wire
Yeah that would be the fuel bowl heater wire.It's on the drivers side of fuel bowl,it has the big rubber boot on it.It's right under the fuel restriction sensor,and it's the bigger one.Hope that makes sense?
Yeah that would be the fuel bowl heater wire.It's on the drivers side of fuel bowl,it has the big rubber boot on it.It's right under the fuel restriction sensor,and it's the bigger one.Hope that makes sense?
Greger96obs
New member
- Joined
- Aug 24, 2011
- Messages
- 26
- Reaction score
- 0
Harness
There's the fuel bowl wire harness and the only one you need is the one I mentioned.I have a nice pic on my phone of the fuel bowl with everything labeled.
There's the fuel bowl wire harness and the only one you need is the one I mentioned.I have a nice pic on my phone of the fuel bowl with everything labeled.
gnxtc2
Active member
Not the best pic but I cut the end off the fuel heater wire and crimped on a Weatherpack terminal.
Billy T.
[email protected]
Billy T.
[email protected]
