Dirtclod
New member
Ok this one is for the wire gurus. I’ve purchased an OBD2 Bluetooth connector Lelink for iOS iPad/iPhone. I’ve downloaded 3 apps,engine link,OBD fusion,OBD evolution. All of the apps connects to device but not the pcm. It does fine on my 96 Chevy s10. I’ve taken the connector loose from under the dash and I have 7 pin outs. I have 3,4,5,7,10,13,16. According to what I’ve found researching I should have pin #2 tan/orange. Hanging down from the harness at the connector it appears a light blue/ yellow wire has come off or pulled out. This is for scp bus+. Anyone have any ideas?