UVC ohm question

[OSCS]

Testing my UVC harness and I'm measuring resistance. I'm getting 2.4 ohms for all of them (checking from center pin to each correlating small pin. What are the suppose to be at? I've check all of the injector wires and they are around .2 resistance

 

[Gary]

All you need to have continuity is one strand of wire, so I don't think that is the best way to test a circuit. First check for any melted spots, bad pins, anything visibly wrong, then if I want to still check a circuit I will add a sealed beam headlight to the circuit. if the seal beam lights up and carries the load the circuit is good.

 

[ghohouston]

That resistance is in check