zf swap

[bmack31]

quick question guys. im doing a zf swap in my obs and im wondering id im going to have to change computer control module out? any other weird parts im gonna need besides trans and driveshafts? thanks alot guys

 

[Binder man]

Mandatory: trans, shafts, pedals, ZF wiring harness, master/slave, manual floorplate

Possibles: computer, steering column, crossmember

I'm sure I'm forgetting something. Its been a few months since I've done one

 

[bmack31]

wiring harness! i was forgetting that,

 

[old man dave]

You can use the auto truck harnesses. Have to install a jumper for neutral start at Transmission Range Sensor plug pin 5 (White/Pink) and pin 8 (Red/Lt Blue). Hook up stick backup light switch wires to TRS plug pin 7 (Pink/Orange) and pin 6 Black/Pink).

Remove Clutch Position Switch jumper plug (for auto trans) and install Clutch Position Switch from stick truck into connection plug. Wire colors are Pin 3 Lt Green and pin f4 Tan/Lt Blue. Switch located on clutch linkage. This is for clutch/starter interlock.