Recent content by pstk5088

No kidding, I'm right by there. Good to know.

I haven't been able to check this yet, but in case I need to replace either, any recommendations? I've been looking at the PMF stuff, anyone else?

I've got a shake, seems like the "death wobble'" but only when i hit bumps. Going down the highway normally, I have no issues going 80 or even faster, but hit a bump, and the steering wheel literally jerks out of my hands. The truck is a new to me 2006 F250 with a ProComp 6" lift, 325 Nittos...

Sold, thanks PSA.

$800 shipped

Specifically, this is the Stallion model, for those interested.

Its the stock replacement one, like the one supplied with a BTS trans. I recognize the pic in your avatar, seen your car before in a lot of x275 coverage before, impressive numbers.

$800, buyer pays shipping

$875 shipped!

Don"t be afraid to make an offer, I am more than willing to make a deal!

I have a Precision converter that i purchased used, then had Precision go through it and freshen it up. I did this roughly three years ago and still haven't gotten around to putting it to use. It has not left the box it was shipped in other than to take pictures of it. This is a fresh...

Sorry, what I meant was that the ones that were already painted were no longer available, one that is raw and ready to paint can still be purchased.

I bought one about 3-4 years ago when they were still offering them already painted. It fits very well and attaches very securely using clips in the factory bottom spots, instead of zip ties. That being said, I slid off the road over the winter and had to replace my grill and bumper, the body...

Any of this still available? I need the header panel, bumper, and tow hooks. Thanks in advance. Sorry, I know this is an old thread, thought i'd give it a shot though.

If you don't mind me asking, what shim did you end up with for the right pinion angle? I recently finished putting my DJM kit on, and ended up raising the rear end due to a horrible vibration around 70mph. That is using the supplied shim from DJM, I think it is 4 degrees.