Search results

  1. Powerstroked

    Start, stall, start, stall, start, stall, start

    So I have seen this post on more forums than I care to count and none lead to an actual repair. This morning on the way to work my truck was running great and just randomly stalled. I pulled over to the side of the interstate and it started right up and ran great again. About 2 miles down the...
  2. Powerstroked

    Fuel Pressure

    Ok, I have had it with this problem. In December I started to have hesitation and idle problems at startup, accompanied by some surging at stop signs. I began with installing a fuel pressure gauge that showed a fuel pressure problem. First thing, I was on the line with Air Dog, replaced the...
  3. Powerstroked

    6.0hmy no start/ hard start

    Ok so I know this thread seems like it is just another 6.no-start. My situation is a strange one. So about a week ago the truck started showing signs of hard start and it was a bit sluggish...not to much though. The hard start issue turned into a no start when hot issue, and then it was even...
  4. Powerstroked

    04 Ran great shut off no start

    Ok so I am at a loss. Truck has been running incredible, took an 1800 mile round trip with an average 15 mpg, have been driving around for about a week after trip and truck has been super smooth. Today I drove to work and came home with no hits, misses, or stumbles. Went to run to the grocery...
  5. Powerstroked

    Moody Truck

    This may seem weird to some, but I hope someone will pop in and give me some insight. My truck will run smooth with great power through all RPM ranges and then it will have days where it is sluggish with a bit of a rough idle. It will also not last the whole day, sometimes it will go away when...
  6. Powerstroked

    Dash two guage

    I have a dash two gage pod for a 99-03 new never installed, got this for my truck and realized it was the wrong one. $50 plus the ride.
  7. Powerstroked

    DIY Oil Bypass with external cooler.

    As I was parting together my Oil bypass system I had went to a swap meet and noticed an oil cooler with 3/8 barbed input and output, It was small and the perfect setup to add to my bypass as an additional cooling tool for the 6.0. I admittedly had about a 12 degree delta on my EOT and ECT, this...
  8. Powerstroked

    Patrick at Swamps

    Thanks for Pat at Swamps Diesel for turning me on to a new place to spend hours with people obsessed with the PSD like I am.

Latest posts

Members online

Top