powerstroked08
Active member
That I don't know. If not I don't think it would be that hard to fab one up, or modify a manual lever to work.
webb06 official build thread
- Thread starter webb06
- Start date
webb06
Active member
Little update. Things are slowly progressing this week.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
2good2Btru
Member
Sweet
Sent from my iPhone 6+ using Tapatalk
Sent from my iPhone 6+ using Tapatalk
powerstroked08
Active member
Because race truck!
drunk on diesel
New member
- Joined
- Sep 7, 2011
- Messages
- 4,179
- Reaction score
- 0
me rikey where this is going!
forgive me for asking something that's probably been covered, but whose dual pump setup is that? TIA
forgive me for asking something that's probably been covered, but whose dual pump setup is that? TIA
webb06
Active member
Morgan built them for his pull truck originally.
Sent from my iPhone using Tapatalk
webb06
Active member
webb06
Active member
Everyone likes pics so here's how far I've gotten. Waiting on the fuel cell to arrive so I can plumb in the low pressure side and get the filters and pump all mounted. Also reworking the down pipe so that it'll fit without running anything.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
- Joined
- May 22, 2011
- Messages
- 15,240
- Reaction score
- 1
weak !! haha good luck buddy you got this.
drunk on diesel
New member
- Joined
- Sep 7, 2011
- Messages
- 4,179
- Reaction score
- 0
looks killer man! looking forward to vids, numbers, etc. 
Crack85
Active member
Looks good buddy!
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
webb06
Active member
Got the down pipe done.
Now accepting ideas for a wastegate pipe....not sure if I should put an egr pipe back on and put the wastegate below kinda like the h&s kit, or take it straight out the back and go down beside the trans with the gate mounted as the egr provision pipe
Sent from my iPhone using Tapatalk
Now accepting ideas for a wastegate pipe....not sure if I should put an egr pipe back on and put the wastegate below kinda like the h&s kit, or take it straight out the back and go down beside the trans with the gate mounted as the egr provision pipe
Sent from my iPhone using Tapatalk
webb06
Active member
This is a strong candidate here. Cut out the bellow and just do a straight pipe down passed the manifold
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
StrokiNDieseL
New member
webb06
Active member
Exactly what I was hoping for! Thanks for the pic
Sent from my iPhone using Tapatalk
StrokiNDieseL
New member
Mine finally wrapped up last week & that's the route we took. Wrapped it mainly to keep heat off trans. cant wait to see your #'s either!
NathannialD
New member
Why not just tie into the downpipe the way that kit was meant? Not being a smart a ss. Just curious
