Recent content by 07pstd

0
5r110 modded direct clutch solenoid

Ya I know. Just thought of putting it in once it's fixed is all. Do you have a website or just call to order?
- 07pstd
- Post #11
- Dec 24, 2014
- Forum: 6.0 Aftermarket
0
5r110 modded direct clutch solenoid

Yes unfortunately. I just reading a lot about these modded solenoids, and guess my only question was. Should I put this in to help upgrade it, or it really not that much difference, and just save my money.
- 07pstd
- Post #9
- Dec 24, 2014
- Forum: 6.0 Aftermarket
0
5r110 modded direct clutch solenoid

Yes I agree with u on that. I just wasn't sure if it's something I put in once it's fixed for helping Trans for the future. I won't know what's actually wrong till atleast next week due to holiday. All I know is pan is off it and tested solenoids. But said it's internal, thinks the direct drive...
- 07pstd
- Post #7
- Dec 24, 2014
- Forum: 6.0 Aftermarket
0
5r110 modded direct clutch solenoid

I'm not sure on the Trans taps to be honest. I know the guy tested all solenoids and they tested good on the electrical side. The fluid is bright red like the day it was put in. I just didn't know, if this solenoid is something that would help prevent this issue for the next time. Or if I just...
- 07pstd
- Post #4
- Dec 24, 2014
- Forum: 6.0 Aftermarket
0
5r110 modded direct clutch solenoid

Had my Trans built two years ago and Trans guy thinking my direct clutch went out. Was having the 3-5 flare and just lost reverse. My question is, should I put this solenoid in or is it more of a tuning issue? The 3-5 flare was very minimal, truck pretty much went all in one day. Truck is 07...
- 07pstd
- Thread
- Dec 24, 2014
- Replies: 19
- Forum: 6.0 Aftermarket
0
6.0 help

Thanks guys for all the info. Have a guy I know from ford going to bring the computer home maybe this week if not next and hopefully find out little more of what's going on.
- 07pstd
- Post #21
- Apr 9, 2013
- Forum: 6.0 Tech
0
6.0 help

Drove it a bit last night, and this morning and lowest I could get the fuel pressure to was 46.
- 07pstd
- Post #15
- Apr 6, 2013
- Forum: 6.0 Tech
0
6.0 help

Seems like if it was dropping like that it run like crap, but at wot throws ya back in the seat and runs like a raped ape. I had someone tell me the drop in pressure could be a leaky fuel injector that true?
- 07pstd
- Post #14
- Apr 5, 2013
- Forum: 6.0 Tech
0
6.0 help

After. I don't know what it was before to be honest because I installed a fuel pressure gauge at the same time as the spring.
- 07pstd
- Post #11
- Apr 5, 2013
- Forum: 6.0 Tech
0
6.0 help

Fuel filters are two months old. Fuel pressure at wot I've seen as low as 35psi, at idle its 60 to 61. I have put in new blue fuel spring, and 6.4 banjo bolts on the fuel lines.
- 07pstd
- Post #9
- Apr 5, 2013
- Forum: 6.0 Tech
0
6.0 help

Finally got to put multimeter on it after having to buy two. Key on 53.5v, and cranking to running 54v. Am I still ok ? And when is a 58 consider bad?
- 07pstd
- Post #6
- Apr 4, 2013
- Forum: 6.0 Tech
0
6.0 help

Sorry. I will check with him again but could of swore he told me no. He has had it awhile maybe he needs to upgrade it. I assume the the ae test on the ficm isn't accurate ? That said Is a 58v bad when it's anything less, or is it just bad for injectors once its below 48?
- 07pstd
- Post #4
- Mar 27, 2013
- Forum: 6.0 Tech
0
6.0 help

07 running rough cold pulled dtc had cylinder three power imbalance got a hold of a friend with a ae which was like two weeks before he finally had time but hooked it up pulled dtc again cylinder three code gone didn't show up so tested ficm 52 buzz tested injectors all good engine was warm tho...
- 07pstd
- Thread
- Mar 27, 2013
- Replies: 20
- Forum: 6.0 Tech
0
P0269????

Oh know kidding where about I drive truck and deliver all around my terminal is in yorkville
- 07pstd
- Post #12
- Feb 7, 2013
- Forum: 6.0 Tech
0
P0269????

Remsen 20 mins north of Utica
- 07pstd
- Post #10
- Feb 6, 2013
- Forum: 6.0 Tech