Recent content by Austin@MidwestDiesel&Auto
-
6.7L Turbo piping kit
Putting some of these kits together today! We will have plenty of these in stock after today! :rockon:- Austin@MidwestDiesel&Auto
- Post #6
- Forum: 6.7 Aftermarket
-
Turbo Selection
We would be more than happy to set you up with a retrofit kit! We can do a stock 15 charger swap which will give you a little boost in power and get rid of that troublesome turbo in there now or we can upgrade you to the towmaxR or streetmaxR for even more power. Those kits will come with...- Austin@MidwestDiesel&Auto
- Post #6
- Forum: 6.7 Aftermarket
-
long crank and rough idle
How long is "a long time"? Any codes? What is ICP doing?- Austin@MidwestDiesel&Auto
- Post #2
- Forum: 6.0 Tech
-
-
Please help! Have some codes and trying to figure out what to replace
p0283 - Fuel Injector 8 Control Circuit High Voltage p0284 - Cylinder 8 Balance / Contribution p2285 - ICP Sensor Circuit Low- Austin@MidwestDiesel&Auto
- Post #4
- Forum: 6.0 Tech
-
xtreem x tune
I had it for a while also and did not like the way it popped out of overdrive right at 50. I found myself speeding around just to keep it in OD too. It pulled pretty good in OD though., with 190/100's.- Austin@MidwestDiesel&Auto
- Post #9
- Forum: 6.0 Aftermarket
-
Diesel leak.
Might as well. New washers at least...- Austin@MidwestDiesel&Auto
- Post #16
- Forum: 6.0 Tech
-
Diesel leak.
Glad you found it. Some of those leaks can be a PIA to find. :thumbsup:- Austin@MidwestDiesel&Auto
- Post #7
- Forum: 6.0 Tech
-
-
TURBO SURGING??? HOW TO FIX? HELP...
Sometimes a the vgt portion of the turbo is beyond the cleaning point. Depends what the unison ring looks like etc... It is also possible that the vgt solenoid is going bad. My truck did the same exact thing a while back with my stock turbo. Mine just needed cleaned but it started to come back...- Austin@MidwestDiesel&Auto
- Post #3
- Forum: 6.0 Tech
-
coolant filter system ordered...
Just open the radiator drain, put the garden hose in the degas bottle and let the truck run. When you go to put ELC in the truck, get "silicate-free" coolant and use distilled water with it.- Austin@MidwestDiesel&Auto
- Post #2
- Forum: 6.0 Tech
-
Diesel leak.
Like 05wh250 said... Try following lines from the heads back to the filter housing and then back to the frame from there. make sure all banjo bolts are tight and have copper washers on them.- Austin@MidwestDiesel&Auto
- Post #3
- Forum: 6.0 Tech
