Recent content by CANbus

C
Obs 7.3 efuel DIY wiring diagram

Return goes to the tank. Would like a prime that auto stops in case I need to leave the key on. Does the heater wire stay hot all of the time? I thought it was temperature dependent.
- CANbus
- Post #14
- Jun 10, 2022
- Forum: 7.3 Aftermarket
C
Obs 7.3 efuel DIY wiring diagram

Thanks. I was looking at the Holley version. Now looking into a timer setup that has a 3-second prime and does away with the oil pressure switch.
- CANbus
- Post #11
- Jun 10, 2022
- Forum: 7.3 Aftermarket
C
Obs 7.3 efuel DIY wiring diagram

Do you recall which NO/NC oil pressure switch you were using? I'm looking at doing this and keeping it looking as factory as possible.
- CANbus
- Post #9
- Jun 10, 2022
- Forum: 7.3 Aftermarket
C
Upgraded Power Steering Pump Installed

That takes me to all of the pumps. A brand and part number would work easier.
- CANbus
- Post #110
- Mar 10, 2022
- Forum: 94-97 Aftermarket
C
Upgraded Power Steering Pump Installed

Do you know if that pulley is the right one? I've seen those, but it lists compatibility with the gas engines too. The gas engines have different pulley size than the diesel. I see it lists the F series as well.
- CANbus
- Post #108
- Mar 10, 2022
- Forum: 94-97 Aftermarket
C
Upgraded Power Steering Pump Installed

Any chance you could measure these and post up the dimensions? I'm looking at the entire list of Dorman pulleys and would like to see if one matches.
- CANbus
- Post #106
- Mar 9, 2022
- Forum: 94-97 Aftermarket
C
Do you have measurements for the SD pulleys you used for the power steering pump swap?

Do you have measurements for the SD pulleys you used for the power steering pump swap?
- CANbus
- Profile post
- Mar 9, 2022