Recent content by Hickboii

  1. H

    Rough idle shakes when accelerating loss of power

    We are. I'm thinking with tax money. I want to put some stage 2 in it. I was looking at dp tuners programmer. Like I said I already had the trans done. I pull a 30' toy hauler pretty regular. It weighs about 12000lbs fully loaded quads, gas, water ect. So I wanna have a tow mode. The wife drive...
  2. H

    Rough idle shakes when accelerating loss of power

    The light had just come on. We've run it quite a bit lower than that before. Till the comp said 0 miles till empty and never had a problem. Gotta get to the favorite fuel station.
  3. H

    Rough idle shakes when accelerating loss of power

    I run rotella and Change it every 5000 miles. I'm not sure what the test was I wasn't running the machine. It seemed very complicated for my tiny redneck brain. Haha. The way he explained it to me is it shuts of half the injectors and increases the pressure to the others and then does the other...
  4. H

    Rough idle shakes when accelerating loss of power

    Well hooked it up to the scanner today. Ran the buzz test all sounded good. Tried to run a contribution test but the machine kept saying it couldn't communicate. However ran a self test that's increases the oil pressure in the injectors that cleared it up. Now it runs fine. Maybe there was some...
  5. H

    Rough idle shakes when accelerating loss of power

    Right but at the default ICP maps it still was running like crap sorry i left that out. That would mean the sensor is still good right? How else would you test the ICP, short of replacing it for $170? I wiggled the uvc's cause someone else said to do that. I gues I will probably get into pulling...
  6. H

    Rough idle shakes when accelerating loss of power

    No. And I got SCREAMED at for even asking. Haha I checked the cap as well.
  7. H

    Rough idle shakes when accelerating loss of power

    ok i wiggled the uvc connectors and no change. had a buddy come over he unplugged i icp with the motor running and the idle went down and then leveled out so he said that was good. i changed the fuel filter no change. i'm still thinking bad injector as much as i hate that thought. My buddy is...
  8. H

    Rough idle shakes when accelerating loss of power

    You gotta dumb it down a little for me what's a uvc and what does it looks like. Sorry this is all a little new to me it's my first 7.3
  9. H

    Rough idle shakes when accelerating loss of power

    Well I'm going to start with the fuel filter and the ICP sensor. The fuel filter looks like crap and thinking about it now I can't remember how many oil changes I've done since I replaced it last. Not good. The ICP is leaking oil into the plug so it needs to be replaced anyway and I'm hoping...
  10. H

    Rough idle shakes when accelerating loss of power

    So I haven't posted on here much but I need some help. My wife took the excursion to fill up today and after she filled up the truck immediately started running like crap. 2001 7.3l. It's started ruff and idled pretty ruff when I first got to where she was. I drained the fuel separator but it...
  11. H

    Looking for a good trans shop in near Tacoma.

    I've got an 01 ex and I'm looking to get the tranny rebuilt/beefed up.
  12. H

    Putting f-350 springs in my Ex

    Front and rear. Got all new shocks with the springs. Gonna get new u-bolts as well, but first it may be time for a tranny think I smoked it today pushing my moms trailer backwards up a very steep hill. It definitely overheated and puked fluid everywhere but I'm not sure if there is any permanent...
  13. H

    Putting f-350 springs in my Ex

    So im about to put a set of f-350 springs in my ex. They came out of a friend of mines truck, they are 2" lift springs. He had them rebuilt and then decided he wanted more lift and took them back out. I'm hoping my u-bolts aren't that much of a PITA as ive heard they could be. I will start...
  14. H

    Hello all from McChord WA

    I've got a 01 ex 7.3l limited. Haven't done much just a 4" turbo back exhaust and an S&B stage 2 intake. I'm looking at getting a wicked wheel and some stock f350 springs for the rear to aid in towing my 10,000lbs toy hauler. I'm sure I will be picking some people's brains.

Latest posts

Members online

Top