Recent content by jteam
-
J
cylinder leak test question
Gary and Arisley, both very good points! Thanks for the tips guys. I'll have to give it another try when I get a free day with decent weather. Sent from my iPhone using Tapatalk -
J
'97 E350 parts
Harness, fuel bowl, and elbow sold. Sent from my iPhone using Tapatalk- jteam
- Post #7
- Forum: Engine and Drivetrain
-
J
cylinder leak test question
I've not heard it run, can only go on the word of the seller (112k) The intake boot on the turbo wasn't in the greatest condition so the fins have a few nicks in them. However, the fins aren't "rounded off" like my engine which is apparently "dusted " (238k) with all the crankcase pressure I... -
J
cylinder leak test question
The numbers I got cold were all over the place using a harbor freight leak tester. I'm going to go back over the adapter I made from a grease whip and make sure there's no leak. My numbers were in the 50,60,70, percent. At least one sounded like an exhaust valve and several sound like a faulty... -
J
cylinder leak test question
Thanks for the replies guys, posted the same at the "org" and "nation", and not one reply. Sent from my iPhone using Tapatalk -
J
cylinder leak test question
Gary, would you normally see a higher percentage of leakage or generally an acceptable number? I've tried on mine and saw moderately high numbers with it dead cold. I was going to just do a long block swap but now I'm debating. I may try using the block heater and see if there are changes Sent... -
J
cylinder leak test question
Has anyone out there ever performed a cylinder leak down test on a used engine while it is cold? I bought a used 112k mile engine and want to check the health of it before swapping it into my truck, but I am concerned that the test will not be a reliable indicator. So I was curious if anyone... -
J
'97 E350 parts
Bump again, make offers Sent from my iPhone using Tapatalk- jteam
- Post #6
- Forum: Engine and Drivetrain
-
J
'97 E350 parts
Bump for these OBS parts Sent from my iPhone using Tapatalk- jteam
- Post #4
- Forum: Engine and Drivetrain
-
J
'97 E350 parts
The engine was removed from a wrecked 1997 e350 7.3l with 112k miles. I bought the engine recently for my 2002 truck and there will be other parts I can't use in the swap but I just haven't pulled them off the block yet. So the stuff below is all I have available for now. I'm pricing stuff...- jteam
- Thread
- Replies: 6
- Forum: Engine and Drivetrain
-
J
99 7.3L truck parting out
I assume you are keeping the engine? If not PM me please Sent from my iPhone using Tapatalk- jteam
- Post #7
- Forum: Engine and Drivetrain
-
J
1996 complete 7.3 engine Low miles
So did the engine sell? Sent from my iPhone using Tapatalk- jteam
- Post #7
- Forum: Engine and Drivetrain
