Recent content by kjdavis

The LED's themselves wont get hot, but the circuit boards do, which is why LED lights have the heat sinks on the back of them.

Still have these....great deal for lots of light!

Reduced.... $550 shipped. to the lower 48

Still have this setup. The 20" single row bars use 5W CREE LED chips, not 3W like most dual row bars. So you are almost doubling the wattage in the same amount of space with two single rows like these. One is spot and the other is flood so you get excellent coverage! 7500 lumens each...

I have the dual single row LED light bar set up from my truck for sale. Includes a 20" CSI flood and 20" CSI spot beam light bar, KD Fabworks mounting brackets, KD Fabworks wiring adapter to plug one of the bars into your existing wiring. This is a direct bolt-in, plug and play (one bar)...

Is the 08 lifted? Usually death wobble is from worn steering components; tie rod ends, drag link, track bar bushings, etc. Have you checked all of them?

Not that I know of. Whoever it was stole the truck, then stole a motorcycle and put it in the bed.....then yanked the center console and front passenger seat before dumping the truck AND motorcycle into the river. A fisherman upstream saw someone dumping the truck and called the cops. Cops...

My father-in-law pulled his out of a river after some jackass stole it, used it to steal a motorcycle, then dumped both.

Anyone with a Rigid RDS curved bar? I need to ask a favor, if you could measure the mounting holes on the bar itself....there are two bolts per side and I need to know #1: the distance between the two holes center-to-center, and #2: the size of bolts I would greatly appreciate the help!

Or....stack two SR 40's in the bumper.... a single row puts out close to as many lumens as a DR...so putting two SR's in there would be insanely bright.

Yes, the tow hooks have to come off unfortunately.

Sent you a PM

40" 30"

Love the look of your truck. What rear bumper and light bar you going with?

Had it towed back to my house so I could replace the water pump that went out. The plug for the weep hole ended up wedged in one of the pulleys. Bearing behind the pulley is toast with metal shavings everywhere. A little bit nasty Going to do a flush and get it all cleaned out. On a...