Recent content by LowFlying7Three

SOLD Sent from my iPhone using Tapatalk

I have what I am pretty sure is a complete valvetrain from the lifters to the rockers for a 7.3. If I’m not mistaken it’s from a 2000, but it’s been quite a few years since I stashed it. I don’t need it, if someone is interested make me an offer. I will pack it good and send it in a USPS medium...

Open to reasonable offers if someone is interested, would really like to move them Sent from my iPhone using Tapatalk

SOLD Sent from my iPhone using Tapatalk

SOLD Sent from my iPhone using Tapatalk

Yes. The label says it will work on any 96-up OBD enabled vehicle Sent from my iPhone using Tapatalk

$350 Sent from my iPhone using Tapatalk

$275 Sent from my iPhone using Tapatalk

$75 Sent from my iPhone using Tapatalk

$75 Sent from my iPhone using Tapatalk

375 shipped Sent from my iPhone using Tapatalk

Used edge CS2 and EAS3 kit. Had them installed on my 97 and removed it all when I sold it. Everything is there, much of it unused. Fuel pressure sensor and EGT probe was used, temp sensor was never installed. Harness for the fuel pressure sensor was never used. The cable connector was filed down...

Ford pedal, p/n F6TA-9F836-AA, no issue, just a spare I had laying around. It does not have the OEM sensor, I also have another aftermarket sensor I will throw in with it. $85 shipped to lower 48. PM or email [email protected]. Paypal preferred. Sent from my iPhone using Tapatalk

Two rear center caps. Nice shape, but need cleaned up, I found them with some old stuff I was rummaging through in one of my barns. Asking $85 shipped to the lower 48. PM or email [email protected], PayPal preferred. Sent from my iPhone using Tapatalk

Thanks I’ll try to free them up and see if that helps. Didn’t really think about trying that, I’ve never had a set get tight. I’ve got some John Deere graphite and chain/roller lube, I’ll give one of them a try. This truck only has 45k but sat a lot, I’ve been working a lot of bugs out of it.