Recent content by Nic
-
Need a stage 1 5R
Any suggestions? Shes tired. Was looking At Twisted and a few others. No mods other than the usual. IDP street daily. She don’t get driven hard anymore and occasional pulling. Max 8k- Nic
- Thread
- Replies: 3
- Forum: 6.0 Aftermarket
-
Lift pump/high pressures issues
Thanks! I ended up ordering the FASS 140. I’ll shim the spring if I need to. Thanks for the heads up. Sent from my iPhone using Tapatalk- Nic
- Post #3
- Forum: 6.0 Aftermarket
-
Lift pump/high pressures issues
Good morning all, currently been having several issues from my current setup which is an old legacy series FASS lift pump going into an aeromotive high pressure pump up to the regulated return. Wanting to ditch that system and go with one central unit capable of 55psi or so. Any suggestions? Thanks!- Nic
- Thread
- Replies: 2
- Forum: 6.0 Aftermarket
-
05-07 Long bed 4x4 Donor cab and frame?
Anyone have any that are in semi decent shape?- Nic
- Thread
- Replies: 0
- Forum: Project Forum
-
Regulated return with FASS and aeromotive
Currently have a sump, to an old school FASS red base pump, pushing to an aeromotive pump, then through a big CAT filter, and then to the regulated return setup. I need to replaced some old fuel lines this week and do y’all think I’ll be ok with doing away with that CAT filter after the... -
-
Valve cover gaskets
When replacing the valve cover gasket, what else has to be replaced with it? Any injector O-rings or tubes too? -
-
-
Anything new?
Ok I guess that solves that. Is there any way better than a typical coolant filter to keep them clear? Maybe backflushing every 6 months or so? The truck has always had a coolant filter but it seems like that prolongs the eventual issue rather than prevents it. -
Anything new?
About to dive into my 04.5 for injector re-seal, oil rail rebuild , ficm and a few other things. Also considering the high flow oil.cooler from Rudy's. Anyone use it yet? Is there anything else I should consider that anyone has found to be a long term issue while I'm in there or is it just the...- Nic
- Thread
- Replies: 0
- Forum: 6.0 Aftermarket
-
Anything new?
About to dive into my 04.5 for injector re-seal, oil rail rebuild , ficm and a few other things. Also considering the high flow oil.cooler from Rudy's. Anyone use it yet? Is there anything else I should consider that anyone has found to be a long term issue while I'm in there or is it just the... -
Green coolant?
So in yalls experience, what's the thoughts on Rotella ELC as a replacement?- Nic
- Post #9
- Forum: 2017+ 6.7 Aluminum Super Duty
-
Green coolant?
Does anyone know if this is correct from the factory? Did it change? About to take some things off this engine and just wondering if its correct. I couldn't find much online. Thanks- Nic
- Thread
- Replies: 10
- Forum: 2017+ 6.7 Aluminum Super Duty
-
Oil flow valve?
Hope I'm not beating a dead horse as I haven't been on here in a while. I recently had oil temp of 225ish while towing around 6k with my 2012 and the truck cut the power in half from the temp threshold from what I was told. I've heard that the problem is a faulty oil valve in the pan restricting...
