Recent content by nikotmt
-
N
Zf6 conversion 4x4 help
Well I got my conversion done but my 4x4 will not work at all I have been in touch with josh from rcd and he seems to think I need a engine software part number from a manual truck with esof electronic 4x4 to get mine to work any help would be appreciated 6.4 zf6 :bowfast: -
N
6.4 auto to zf6
It appears to me that I may have the same problem ford cannot communicate with my truck at all. Any help would be appreciated thanks -
N
auto to zf6 HELP
I put them in touch with Levi from river city diesel he said he would walk them through it thanks Levi -
N
auto to zf6 HELP
Well I'm done with my swap except ford cannot flash my pcm to that of a manual strategy does anyone have any clue how this can be done ansmd keep my vin so my ecms don't throw a mismatch error and put it into protection mode. Any help they say they cannot modify as-built data so. What now. Help... -
N
6.4 auto to zf6
i need a wiring diagram for a manual all i can find is the automatics i need to wire up my clutch pedal position sensor any help??? -
N
6.4 auto to zf6
IF i can supply my vin can anyone modify the as-built data for me to be configured as a manual seeing that they did not offer a lariat with a manual trans. that is all i need to get this truck running. thanks -
N
6.4 auto to zf6
thanks i wasnt sure appreciate the help one more thing i need a vin off a 2008 6.4 manual trans truck so i can pull up the as-built ecm software any one help me out thanks in advance -
N
6.4 auto to zf6
i got a nother question i got a automatic t-case where will the vss signal come from there is two connectors on the t-case one on the electric motor itself and a 6 pin above the housing of the motor is this possiby a speed sensor and a position sensor there is only one sensor on the zf6 that... -
N
WTB: 6.4 manual floor pan
in need of tunnel doing a auto to manual swap dont need entire pan just center section and help greatly apperciated:lookaround:- nikotmt
- Thread
- Replies: 0
- Forum: Want to Buy
-
N
2008 2009 2010 manual trand tunnel
im doing a auto to manual swap any one got a rolled 08-10 with a manual trans they want to sell the tunnel out of i need one asap thought i had it in the bag but seller realized that was not what he had now im stuck :fustrate: -
N
6.4 auto to zf6
thanks i had seen that thread earlier and it seems ike he ended up having issues wasnt quite sure what he ended up doing sent him a message no reply thanks i'll keep you updated thanks -
N
6.4 auto to zf6
I have a fully loaded 2008 lariat in the process of a transmission swap and need help understanding the engine computer part number differences. what engine ecm would work. seeing that my current ecm is an auto what electronically needs to be flashed. i am also looking for information about...
Members online
No members online now.