Building a pipe bumper for the front of a 78 Bronco. This should push stuff out of the way. The bumper is 5” pipe 1/4” thick wall steel, so is the Bull Bar. Will also add a receiver then can use the winch front or rear. Think this will look much better than that 1 1/2” tube.
There are lots of options for small welders, lots of multi voltage machines. Stick with known brand Hobart 200, or 211, Miller 211. These are good machines for the garage
Here is my intended use of the hoist on the welding table, help with holding an fitting bumpers and brush guards. Still may add some out riggers. It’s lighter and easier to move than an engine hoist, the table is great for add ons
Hurt my back again, still have to get things done. So I added casters to a small welding table, then added a receiver to the bottom. Then added wire rack shelving. Now I can add a receiver hoist to lift and move stuff like bumpers around the shop. This should help me keep from aggravating this...