Recent content by randylamarr

Well my truck is having an issue when I shut it off and open the door the dash and radio stay on I thought it was possibly the drivers door latch so I tried to open the passenger door still nothing shut off anybody have an idea of what switch I should check or what I should be looking for thanks...

when I hook the scanner up it tells me that it can't communicate with the TPMS. On the dash i have a Tire Pressure Fault. I replaced all the sensors to no avail I believe it may be the truck module. Who else has experience with this and what did you do I hate the dummy light on the dash. And...

It will not communicate with with the tpms system I'm thinking a ground or BCM issue Sent from my iPhone using Tapatalk

Well guys I have been chasing an electrical issue for a couple weeks now. Truck runs and drives fine but I have no AC as well as check brake system and tire pressure faults on the dash. But yesterday my blinker indicators on the dash started not act up when I first turn on the key the...

well guys and gals i have found the part number that Im looking for its 8c3z12a581ja really need some help finding this!!

Well guys I'm looking for a complete engine harness I couldn't get my issue fixed with a pcm so now I need a harness to see if that fixes the problem Sent from my iPhone using Tapatalk

Well after flashing a new PCM my AC still will not kick on so I need to know if someone has a pin diagram for the plugs that go into the PCM I need to find the AC clutch and the brake fluid level sensor Sent from my iPhone using Tapatalk

I will have a short bed with linex liner in it that I will put new cross braces on as well as paint to match for $2500

this POS sucks I hope the PCM fixes it after it gets flashed

Well I have found my problem the PCM has problems the AC circuit seems to be fried when i jump the compressor relay with 12 volts the compressor kicks on but when the pcm is plugged in i only get 4.3v so have found another PCM that Im going to try to see if that fixes the problem and if it does...

nope!!

I put a new abs sensor in and the abs light went out but the check brake system and red light is still on the dash. All the wheels spin no brake is catching Sent from my iPhone using Tapatalk

The damage was front passenger side hit basically between bumper and wheel and when through the wheel well Sent from my iPhone using Tapatalk

Ok so I also unplugged the e-brake pedal and switch and the light is still on! Brake fluid is full but is there a wire that I should check? The display says check brake system Sent from my iPhone using Tapatalk

the code was P0646 A/C clutch relay control circuit low