Injectors won’t be blue that’s oil-ish smoke. Check compression for ring clearance otherwise check heads for valve stem seals.
Sent from my iPhone using Tapatalk
Just checked The boxes are up to 07-30-2007
And then after 08-01-2007
So by what you said you are 02-2007
So you can not upgrade your box unless you get a new column. Or replace the end.
You would need to be 08/07
Sent from my iPhone using Tapatalku
2011-2016 not sure about 17
Just make sure your build date is after 08/08 or else you will not have the same type spline for the steering column.
Any 11-16 will work and is updated with a tighter recirc ball.
11-16 will be a direct bolt in with no drilling which I would use as you could harm...
UPDATE: pin 2 on the encoder motor was corroded, yellow with white tracer, spliced in spare connector, all was good. Thanks guys!
Sent from my iPhone using Tapatalk
Okay yes I understand that. Pretty sure his hubs are unlocked. But even so if they were locked I don’t think it would keep the engine from shifting like its in a Low Gear.
Sent from my iPhone using Tapatalk
And can you explain more about the hubs being unlocked and tcase spinning the front shaft? Not clear to me. Thank you.
Sent from my iPhone using Tapatalk
Electronic,
And if the motor was bound up, that would cause the light not to show up?
I read that there is a connector 2 wire I believe that grounds either for the high and low lights. Can anyone with a diagram confirm? I’ll try grounding both, I’m on Holidays for 2 months. And I won’t have...
Have you looked at the transmission strategies, make sure the tune is the same trans strategy?
There is tqje and tqjf if you load the wrong tune you’ll have reverse only no forward gears.
Sent from my iPhone using Tapatalk
Long story short, I’m a mechanic, I would like actual techs or professionals only respond. Thank you.
Did up pipes and a tranny on a 6.4
Tranny is a #50 casting from a 6.0,
Replaced the TC with a 6.4 TC
Cut and spliced in a new TCM connector with the 10mm bolt going through it to the...