Recent content by toybreaker

I have an airbag light on (code 27) and my cruise does not work anymore (on button fault code {do not remember the specific code}). Clock spring is not going to fix my issues, and the code 27 is a bulb that is integral to the passenger airbag on/off switch...... $.37 bulb Need to replace a $70...

keep getting p0603 kapwr fault p0640 intake air heater P0542 mani intake air temp hi P1536 parking brake switch P0565 cc on switch P1876 transfer case 2wd solenoid short B1575 parking lamp switch failure B1884 pass airbag disable lamp failure C1446 brake switch circuit failure Had idm low...

Little bit Sent from my iPhone using Tapatalk

should be 3/32" .0938" od to id thickness

SO if BA's are stage 1 AC's why is it such a pain in the arse to get superduty nozzles on my BA's?

Keep it moving....I am trying to find a set of 17 or 18's to put on my 01. People seem to think they are worth 80% retail for some reason.

Good thing I was not drinking coffee when I read that. I laughed out loud. Air hammer is in the barn with the big compressor.... And my big vice is in the storage container with the disassembled workbench. I quit once I got to that point last night. After work today I get to pressure wash the...

What i had to do to get the fan and pulley off of the old one Sent from my iPhone using Tapatalk

Autozone/duralast (limited lifetime warranty) paid $169? (in 2009) Failed on saturday, 1/2 mile from home, 11 years and 80kish miles. Replacing hoses, fan clutch, thermostat, full cooling system flush and inspecting the degas bottle.

I can see your points. I have heard good/bad things regarding running single shots in a splitshot truck. Tuning is everything. And trying to get a builder to "rebuild" my BA's into stage 2's is a pain in the ass. So take the improvements in tuning to get efficiency and power, and add in the...

That is good info, using the split shot b’s means I can theoretically run them without any special tuning....... so it would be a get them swapped to t444e nozzles, verify the rest of the specs, get some fresh o rings and send em. Sent from my iPad using Tapatalk

I “retired” from the military, and work 50-100 hours a week at my next career. So i have limited time, like most everyone else. But unlike most i have a personal manual machine shop to dick around in when i find the time. And after i build my 4 car garage i am buying my neighbors VMC. Vertical...

Yes I see that the market has shrank, but the fact that I still have mine and this idea still rattles around in my head without an answer bothers me a bit, Kind of like actually seeing a small block ford shortblock running with LS head on it. seen mock up photo's but never seen video of one...

Yes I see that the market has shrank, but the fact that I still have mine and this idea still rattles around in my head without an answer bothers me a bit, Kind of like actually seeing a small block ford shortblock running with LS head on it. seen mock up photo's but never seen video of one...

Sorry to revive a 5 year old thread but I started a discussion about this on PSN years ago and never got any answers. My direction of inquiry was for efficiency and MPG. Stock nozzle is 7 hole at .0065" orifice so theoretically dropping the diameter and increasing the number of holes will...