Recent content by Urban Wheeler

they are great batteries, i've been running them for 5 years now. just had to warranty them out becasue the timer went bad on the battery charger and fried them.

I built a gen 3 setup with a 4 line feed. im using the normal 4f665 pump with the correct pieces flipped to make it left hand rotation. the truck will start and idle fine then starts running rough and under throttle will die. i pulled the plug on the res to check oil level and the oil was very...

the cast reservoir was $20 NIB on ebay, kinda hard to pass up. as you know they are not available new and haven't been for awhile. you should see the engine now with the nitrous and water/meth lines run. it looks like 2 octopus fighting in there.

i didnt get a valve in my kit, should i have? will the water leak through the pump when its not in use?

finally getting around to installing my water/meth setup. its a cooling mist single pump kit with two nozzles. i am wondering how close together the nozzles can be, or if it matters. the easiest place for me to put them is in the pre-intercooler pipe, 16-18" apart.

Tru Trac hands down for a daily driver. i am running them front and rear, they have great street manners and will work when you need them.