Recent content by weweld

replaced and now it's running THANKS :D:D

A bad EBP sensor :cursing:

Thanks will double check those

If I unplug the engine harness from the pcm the fuel pump runs and the starter engages , got a harness and pcm on the way , Thanks

Looking for and engine harness and a pcm for a 2004 F250 6.0 auto.

no communication with a scanner. No fuel pump and no starter. 04 F250

Just found this at the Association of Diesel Specialist's... This 2004 F-250 that had a issue. This was a 6.0L that would not crank, reflash or run self-tests or program the PCM either. I have learned that these two engines use three connectors wired to the PCM. There is an engine connector...

even has my local ford tec puzzled

put in a new pcm today and the fuel pump came on the starter engaged and the motor cranked over for about 5 seconds then everything stopped and I'm back to where I started :slap:

Truck started fine yesterday then died , Turn on the key you get no fuel pump and no cranking. also the glow plug light stays on real long used to be on just about 10 seconds. If I unplug the engine harness at the pcm the fuel pump runs and the starter will crank. Checked all the fuses and...

New shoes for the old girl !!

Looking for the glow plug harness for both sides for an 04 F250 6.0 Thanks

I will be there !!

Looks good glad to see it running again :redspotdance:

Looking for a set of power , heated tow mirrors 2000 and up