Search results
-
0
center console shifter in super duty
I also have this done in my truck. I went the cheep/ easy way. I built a fiberglass box with holes for gauges up front then the shiffter, an on the inside i hide my amp an stand alone for my trans. Sprayed itvwith glue andno raped in carpet. Not the cleanest setup im shore but i like it.- 00fummins
- Post #13
- Forum: Aftermarket Super Duty 1999 - Current
-
0
Couple of issues I need help identifying
Most likely that is what you will have to look at. Im at a bit of a loss for the reason it is not connecting. What scan tool are you using, just the off the shelf cheep one or a good scan tool?- 00fummins
- Post #7
- Forum: 94-97 Tech
-
0
6.4 owner looking for a 4 digit HP number
Anything is possible with enough nos. Do you want to drive around with 1k hp or just to do it one time on the dyno?- 00fummins
- Post #4
- Forum: 6.4 Aftermarket
-
0
Couple of issues I need help identifying
If you run the truck down the road with the scanner hooked up it should tell you if the tc is locking and unlocking or lack there of. I would be more concerned about it stalling.- 00fummins
- Post #4
- Forum: 94-97 Tech
-
0
Couple of issues I need help identifying
check all grounds. How olds the turbo? last time cam sensor was replaced? More info on symtoms when driving.- 00fummins
- Post #2
- Forum: 94-97 Tech
-
0
Smoke Stack Installation
1 stacks for go, 2 are for show :toast:. Measure twice cut once.- 00fummins
- Post #6
- Forum: 6.4 Aftermarket
-
0
Front hub assembly replacement ??'s
Take out snap ring pull 4x4 hub. Then theres a nut with a few washers, pull that. Take off caliper and caliper bracket. Then 4 bolts behind and it should slide out with a little help from a hammer -
0
4r100 tc an rebuild kit
I smoked my trans and tc. Looking for built tc and good rebuild kit. Could be interested in full built trans if price is right. Thanks- 00fummins
- Thread
- Replies: 0
- Forum: Want to Buy
