Search results

Can anyone tell me what the output is of the stock low pressure oil pump? Like gpm at given rpm? I've been searching for days and got nothing.

Anyone have experience with aftermarket 6.0 radiators? Seems ALL of them are 1/2 the thickness of oem. Doesn't seem right but I can't find a full thickness radiator for a decent price. Any thoughts? Do they work just as good?

What are you guys using with success? I used DEI stuff and after 1 season it all turned to dust.

Hey guys, I'm looking for a good '95.5 front cover. It's the only model cover with a full width rubber gasket under the reservoir and has the pick-up tube mounted on the driver's side (about 7:00 when looking from the crankshaft side.) Must have good oil pump surface. Let me know what you got...

Anyone ever have this happen or see it happen before? I'm trying to figure out why so it doesn't happen again.

I have a set of 4 aluminum Eagle Alloy 16.5 x 12 that are about 17 years old. They have BFG MT's mounted on them (33 x 12.5) that have about 1/2 tread or so, also about 17 years old. They have never been in salt, or seen winter. The truck is stored inside year round and only driven in the...

I'd like to hear from anyone running 300, 350, 400 cc size hybrids, turning over 4k rpms, and what your low pressure oil pressure is. I have an issue that I am trying to figure out and I think it's the HPOP. At the end of a 1/4 mile run the low pressure oil drops below 10 psi for several seconds...

Who has done what when drag racing? I have read, and talked with, many sled pull guys that go to air/water coolers because of lack of air flow through the air/air cooler out front. Any drag racing guys use air/water vs air/air? Benefit of the water cooler over air cooler going 140 mph?

I got a 5R110 and elect shift t-case attached to a '04 6.0 engine I bought. I only need the engine and have no use for the trans and t-case. Selling BOTH trans and t-case together for $250. Come get them out of here. Pick up in Chardon, OH 44024.

Early build April 2010, 6.7 truck in limp mode, we've done everything we can think of and finally found low pressure fuel too high. Our gauge in line between pump and motor reads past 100 psi. I would appreciate any tips on what to look for causing this high pressure.

Anybody have, or know of, or can suggest how to find a fuel filter/water separator similar to the FS1000, but in a higher micron rating like 50, 70, or 100 or so? I would like to try one to see if my electric fuel pumps will last longer. I think 10 micron is too tight to suck through and hope...

Injectors are 175/75% that I fed with a Bosch 044 pump with 5/8" draw straw, and regulated return. I can't recall where I got the return deal 5 years ago, from a guy that got banned from this site for whatever reason, uses hard lines to Aeromotive regulator, then returns back to tank. Factory...

I have accumulated 4 6.0 fuel filters for the pump only. My fuel system retains the upper filter housing so that's the only filter I use. These would be good for the guys that run the 6.0 pump in the older trucks, or whatever, or if you want spares, etc. Make offer.

Got a 2005 6.0 customer's truck here we are totally stumped with and I need some outside, fresh input what to look at. We replaced 4 injectors and the oil pan for the customer. Afterward we fired up the truck and it won't idle. You have to feather the throttle to get it to fire, and you can hold...

I am looking for some spare computers. I need a OBS 5 speed pcm, any DPC 203. And I'd like to get a Super Duty DPC 422 ecm. Let me know what you got laying around.

I have a customer with a fried ECM from removing the chip with the key on. Discontinued from Ford. Anyone got one? Thanks.

I have a rolling '08 crewcab long bed commercial chassis, 4x4, had 6.4 diesel in it. Looking for offers.

Most of the info is here, let me know if you have specific questions. http://cleveland.craigslist.org/cto/5678964748.html

Thought I'd post here for upgrade suggestions. Our shop van is getting very hot while towing. Actually, it gets very hot just driving around, too. I see 215° routinely just city driving. If it's 65° or so outside it's much lower. Towing a 6k trailer isn't much different. The trans hovers at...

I have 2011 F-250 4x4 6.7 truck front-end wreck parts truck I am selling as a whole, I am not interested in parting out at this time. Craigslist link: https://cleveland.craigslist.org/cto/5483601144.html $5500.