Search results

Bump

By stock I mean original

On 140k early 04 were lifters left stock?

I’ll bump this again, I need this gone it is in a truck taking up room in my shop. Bts 4r100, 5 gallons of Schaefer’s atf, 6 position switch with 2 tunes written for this transmission(i believe hot and tow, whatever tunes Bryan sends you out with), and a very lightly used 6.0 cooler that was...

Is hpop still in motor? If so do you have any videos of it running/proof of 107k if so I’ll take it. And can accept it at our business.

I will try that and report back lol. Super inconvenint to deal with.

I replaced the column bushings this weekend, they were bad but it didn’t solve the majority of the slop. Clip on the end of the linkage seems fine doesn’t wiggle. The shifter has a lot of it’s slop before you even pull it to you to change selector position.

No sorry, I won’t go that low.

Bump 3850.00 like I said comes with like new 6.0 cooler and a 175.00 bucket of Schaefer’s to do fluid change.

Ok that picture is just not even viewable, sorry about that if anyone wants a picture of receipt text me at the number above.

Pretty firm but I may be able to work with you if you’re serious. I think I attached the picture. I’ve got another one somewhere on the 2nd page of receipts I believe the total was like 4905.00. You can call me or text me at 865-414-9199

Not billet, I do believe Bryan had them crying treated though.

I’ve got a bts out of one of our f350’s for sale, Bryan built the tranny in October of 2008. Since then I believe but cannot tell you with 100% confidence that the tranny has around 30k miles on it. The truck went down in late 2011 or early 2012 and has been sitting since. It still has the...

Is the motor being sold complete with turbo and injectors? Or is it a part out

My selector has gotten incredibly sloppy. It isn't in the alignment I've already adjusted it with the knob. You almost can't get it in park and to be in drive you've just gotta get lucky. The linkage on the trans is just sloppy how do you or can you adjust it back right.

That's pretty impressive

And Sootie where are you located again? Lol I believe I've found a buddy who will let me use his lift. I like the idea of lifting the cab on my personal truck for the shear fact of I get to steam clean everything. Be nice putting back together a nice clean truck.

Good to see someone doing it on here, my question would be though after putting hands on ever cab bolt and lifting it some anyways is there a way to lift the whole dang thing off without a lift. Just would make life so much easier.

How many of you have pulled an engine cab on? Planning on getting all of my kinks worked out before spring rolls around so I need to get the cab off or the motor out. Cab off is my preference but working on getting an open week on a buddies lift. If not more than likely I'll do the job at the...

Truck has 155k I plan on O-ringing. Is everyone using stock lifters and what about valve springs? I'd love to do them just depends on budget