Search results

G....we need a Gasser forum on here like we had over on the other site!

Just got my package in the mail, thanks again Paul!

Be there!

p1111 System Pass (No DTCs Available) P0107 BARO Circuit Low Input P0l08 BARO Circuit High Input P0112 IAT Sensor Circuit Low Input P0113 IAT Sensor Circuit High Input P0122 Accelerator Pedal Sensor Circuit Low Input P0123 Accelerator Pedal Sensor Circuit High Input P0197 EOT Sensor...

Gooch's Coolant Flush Procedure: You'll need the following: 4 gallons of anti-freeze concentrate. *Tip* Do not use 50/50 pre-mixed coolant. After flushing, residual water will remain in your engine and cooling system that you can't get out. Therefore, adding pre-mixed 50/50 will further...

This is a frequent question on the forums and short of looking for yourself through the inspection port, it was hard to know for sure because apparently some later engines had forged rods after the initial introduction of PMR. I found this recent message on the Hypermax site re:forged rods.

Thought i'd post this up, been around for a long time. Some of the new guys might not know about it, but there is lots of good info on here. http://www.guzzle7pt3.com/index.php

Just looking for some insight on different setups anyone may be running, my steering box may have a couple months of life left but it is on it's way out from running oversize tires it's whole life. I've looked at PSC, ORU and Redneck Ram, not sure if there are any others out there and which is...

Did you get my PM?

Until we reach 1000! :D

Just looking for a set of 18x12's fairly cheap, not in a rush so if anyone comes across any give me a shout

Might as well get photo's and specs all in one place, instead of a new thread every week....PS Need a Nice PSA sticker to replace that PSN one! 2002 Supercab Shortbed, 6.5" of Lift, 18x10 Driv Blitz Wheels on 3.78" BS and 36x15.5 Micky Thompson ATZ's

Glad to see the site up and running!