Reply to thread

Message: [QUOTE="97stoker350, post: 1206432, member: 4064"] Boost is a measure of restriction. There's ur rule of thumb. You can make 50 lbs of boost or 30 lbs of boost and make the same amount of power. The problem lies in how much air you can get into the cylinder i.e. FLOW. I'm no expert but I would understand this stuff first and go from there. Also pressure is not uniform it is exponential. The volume of a 6.7 per cylinder is about 1.2 liters per cylinder. So if you know what ur pressure is under no boost you can find what it would be when you increase the pressure when the piston is at bottom dead center. So find ur max psi without combustion and go up in starting psi. That is where I'd start [/QUOTE]

Verification

Random media

Beeeeeeeer

front_axle_swap9

513

eleanor_part_two_47_

new all-terains

251646_222002947818036_100000249972728_922377_5922724_n

F250

Intake kit

Truck_2008

Latest posts

2010 headunit
- Latest: glog
- Yesterday at 1:17 PM
6.4 Tech
10R140 failure
- Latest: Sterling6.7
- Tuesday at 8:54 PM
2017+ 6.7 Aluminum Super Duty
D
Turning off the Auxiliary powertrain control module
- Latest: donaldtfreeman
- Tuesday at 10:43 AM
6.0 Tech & FAQ
4r100 P0715/P0717 trouble codes.
- Latest: Tiha
- Tuesday at 8:07 AM
7.3 Tech & FAQ
I must be getting old… Exhaust is too loud
- Latest: ju015dd
- Sunday at 7:59 AM
6.0 Aftermarket

Members online

Patrick Feeley

Total: 342 (members: 1, guests: 341)

Top