Reply to thread

Message: [QUOTE="95-F-2FITTY, post: 801418, member: 12509"] thanks justin so i drove my truck tell it got warm on my lunch break today and ran a cyl cont test. When i tried i got a code p1211 "ICP higher/Lower than desired" The switch has intermitent issues so i know i should proably change it but i didnt know if something else could cause it like a ipr. So i cleared the code and tried again and it ran the test and i failed it on cyl numer 3 two times,this is the cylinder i changed the injector on to start with. So i also ran the data stream before operating temp when it idles good the IPR%17/ICP PSI-725 at idle then i ran the data stream at operating temp and it showed IPR%12 /Icp PSI-580 at idle,are these numers ok? ...........................Also when i unplug the sensor there is no change.But if the pcm has switched to default shouldnt it idle right if it was the icp? [/QUOTE]

Verification

Random media

avatar1718

The problem

eleanor_part_two_19_

PMF track bar, overall

iphone_pics_277

johnnykia

20120418_153425

raptor1

101431-I-like-it-a-lot-gif-Dumb-and-D-XKuE

49879E51-01FB-4FF0-B0F2-F0EAEB74242D

left_arm

Latest posts

2010 headunit
- Latest: glog
- Yesterday at 1:17 PM
6.4 Tech
10R140 failure
- Latest: Sterling6.7
- Tuesday at 8:54 PM
2017+ 6.7 Aluminum Super Duty
D
Turning off the Auxiliary powertrain control module
- Latest: donaldtfreeman
- Tuesday at 10:43 AM
6.0 Tech & FAQ
4r100 P0715/P0717 trouble codes.
- Latest: Tiha
- Tuesday at 8:07 AM
7.3 Tech & FAQ
I must be getting old… Exhaust is too loud
- Latest: ju015dd
- Sunday at 7:59 AM
6.0 Aftermarket

Members online

6.7Bison

Total: 225 (members: 2, guests: 223)

Top