Reply to thread

Message: [QUOTE="ditch_dawg, post: 368908, member: 377"] Not knowing these trucks very well (I've only had mine for a few months), but by judging the responses to this post did you confirm that the actuator worked before installing it? Just wondering if the new one was bad. Again don't know these trucks very well, but I would pull it off the blend door/linkage leave the electrical connection attached, start the truck, set the drivers side to full cold then to full hot to see if the actuator rotates. If it does then, I'd install it back on the unit and repeat. Not sure if blend door is pinned to the top or bottom of the unit to where the unit case is the hinge and the door pin actually protrudes out of the case to where you can see if it is moving or not. I've had some new ones that were bad so I'm hoping this is your problem. Without knowing a little more about these I don't have any idea what could be causing the problem. [/QUOTE]

Verification

Random media

08 center console painted meddium pebble to match my 06

SprintPhoto_ecprys

Misc_V-Drive_449

6_4Hopper

Swamps Timing 1

IMG_20130327_174431_727

Mirror plug 3

Edge CS

side_2_coppy

2011-12-11_16-18-53_375

Latest posts

OEM LED sport headlights
- Latest: KBMKVIII
- Today at 9:11 AM
2017+ 6.7 Aluminum Super Duty
10R140 failure
- Latest: PSD-BLACK-CLOUD
- Friday at 1:04 PM
2017+ 6.7 Aluminum Super Duty
2010 headunit
- Latest: glog
- May 7, 2025
6.4 Tech
D
Turning off the Auxiliary powertrain control module
- Latest: donaldtfreeman
- May 6, 2025
6.0 Tech & FAQ
4r100 P0715/P0717 trouble codes.
- Latest: Tiha
- May 6, 2025
7.3 Tech & FAQ

Members online

No members online now.

Total: 420 (members: 0, guests: 420)

Top