Reply to thread

Message: [QUOTE="Bustedknuckles, post: 1092957, member: 2197"] I have a 03 6.0 that I'm diagnosing a crank no start issue on. I have proper ICP, fuel pressure, and FICM voltage. However I am getting no ficm sync and a cam sensor code. My research shows that the cam sensor code can be caused by a extended crank so I'm not too bothered by that however i did swap the cam sensor and clean the mounting location and checked cam and crank signal at the PCM. I have signal from both at the PCM connector but I cannot find a spec or diagram of what the signal should actually look like. A guy who has been a tech for over 20 years said they looked good to him but that doesn't really say anything. What is odd is if I give it a tiny bit of ether it fires up and runs like a top. Any suggestions??? [/QUOTE]

Verification

Random media

Underside_41

IMG_20170708_172332689_HDR

DE_4_Muffler

2013-02-04_13-16-43_486

6_4_piston

1997 ZF5 DRW

Radiator

eleanor_part_two_84_

Morimoto D2S 5.0 Projectors

2012-03-13_12_35_091

Latest posts

10R140 failure
- Latest: PSD-BLACK-CLOUD
- Friday at 1:04 PM
2017+ 6.7 Aluminum Super Duty
2010 headunit
- Latest: glog
- Wednesday at 1:17 PM
6.4 Tech
D
Turning off the Auxiliary powertrain control module
- Latest: donaldtfreeman
- May 6, 2025
6.0 Tech & FAQ
4r100 P0715/P0717 trouble codes.
- Latest: Tiha
- May 6, 2025
7.3 Tech & FAQ
I must be getting old… Exhaust is too loud
- Latest: ju015dd
- May 4, 2025
6.0 Aftermarket

Members online

No members online now.

Total: 606 (members: 2, guests: 604)

Top