Reply to thread

Message: [QUOTE="KBMKVIII, post: 1554965, member: 5718"] First thing, get rid of the plastic IC pipe. Check out smeding for the pipe. Otherwise, weight loss top and bottom . Intakes are good but expensive. I just run a factory filter with some holes in the bottom of the air box and removed silencer. These newer trucks have axle wrap pretty bad so a set of bars is real nice. Have not yet added bars to my ‘16 yet but I need them. I did a low temp thermostat as well. I did not like how high the factory temps were. Don’t care if they are “fine” they were not to my liking. The pse thermostat helped remedy this. Otherwise, check your body bushings. They may look good but are soft as cake. Carrier bearing is worth looking at as well. [/QUOTE]

Verification

Random media

20170409_175907

Screenshots 2

Ford-Trucks-for-Sale1

2015 F350 Before

eleanor_part_two_33_

crowfoot_wrench_2

71A3A56F-62C4-4E77-8278-198DD0A2F533

SAM_00981

pickup_rear

Latest posts

02 F250 7.3 Will crank, WTS stays on, no start, no OBD
- Latest: Sterling6.7
- Sunday at 8:57 PM
7.3 Tech
P0087
- Latest: DEEZUZ
- Sunday at 11:49 AM
6.4 Tech & FAQ
2015-2019 6.7 HPFP New In Box
- Latest: lincolnlocker
- Jun 1, 2026
Engine and Drivetrain
First 6.0L (56k warning)
- Latest: adrianspeeder
- May 26, 2026
6.0 Tech
Extra external motor oil cooler?
- Latest: justinlogue5_0
- May 26, 2026
7.3 Tech

Members online

No members online now.

Total: 2,580 (members: 0, guests: 2,580)

Top