Reply to thread

Message: [QUOTE="silverpsd_06, post: 458204, member: 1011"] Yes that's the the term I was going after thank you tarm.. Basically you start at say drivers side front exhaust port with a ninety degree elbow pointing straight back with a two inch pipe running level with the rest of the exhaust Ports you pick up the next port with a 45 angled back towards the next cut it to fit around the two inch weld it in place and so on until you mate up with the uppies. I'm thinking you may have to split the collector in two to blow the holes out and clean them up to work then weld the other half back together once you exit the Ports. If you can picture that any better.. I don't have any actual pictures of it unless someone else has done it [/QUOTE]

Verification

Random media

2006 F350 CCLB PSD

08 350 cclb white

Dsci0790

rear seat

turbo_vein_actuator

08733985

IMG_20150121_150014_897

458385_10150803517661300_517021299_9998956_891941742_o

2012-03-28_22-54-33_587

Latest posts

S
6R140 surging issue
- Latest: Smokin 6.0
- Today at 12:11 AM
6.7 Tech & FAQ
Won’t start
- Latest: psduser1
- Wednesday at 11:33 AM
7.3 Tech & FAQ
GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Jun 6, 2025
Engine and Drivetrain
Hard steer question/issue
- Latest: psduser1
- Jun 5, 2025
7.3 Tech
B
WTS/WIF light flash and stall issue
- Latest: blickcd
- Jun 5, 2025
6.0 Tech

Members online

Arisley

Total: 249 (members: 1, guests: 248)

Top