Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
New showcase items
New showcase comments
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Showcase
New items
New comments
Latest content
Latest reviews
Latest updates
Search showcase
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Power Strokes
7.3 Tech
7.3 runs horrible after a decent drive.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="hucorey, post: 1429698, member: 13749"] It's pretty rare I ever post with issues, but....lol. I have a very problematic redheaded stepchild customer truck in the shop and it's very odd problem. Truck only runs really bad after being driven for about 25 miles or so. Runs flawless up until that point. I'm not sure if it's a heat soak issue into an electronic device/sensor or not. After the 25ish miles driven, it completely falls on its face to the point it stalls sometimes, acts like it's running on less than 4 cylinders. I mean it's really bad. This is what I've checked/changed. -Injectors were indeed bad as perdels were showing 3 fairly weak and 3 others questionable. Buzz test also showed 6 were a bit quiter. -Found a bad pass side UVCH (Dorman) grounds were bad at the splice. Installed a known good gasket I had and a new Ford harness. Originally had codes for #1,#3,#5 CCT failure. Codes went away after gasket harness swap. -Replaced glowplugs, but this has nothing to do with the issue -customer installed Autozone cps, I replaced with Ford CPS (it did have a cps code that went away after the Ford cps swap) -checked FPR spring, as I've heard broken spring after warm up could cause excessive fuel pressure loss. That wasn't it. -customer had previously installed new IDM with no change. -customer changed the fuel pump too, no change. -unplugging ICP sensor made an ever so slight change to idle, but still ran like poop after warmed up. ICP IPR numbers look great CCT passed perfect after injector swap EOT sensor works In fact all sensors available look fine via AutoEnginuity, even when running like crap and no codes. Once it's reaches the running horrible stage, it even idles horrible. ICP/IRP look great at idle too. If I shut the truck off and leave it set for a few, starts right up and idles/drives fine until it gets to full temp again. Are there any other permissives that the engine NEEDS to see to run properly besides the obvious? Sent from my SM-G900V using Tapatalk Sent from my SM-G900V using Tapatalk [/QUOTE]
Insert quotes…
Verification
Post reply
Random media
Latest posts
T
2023 f350 6.7L
Latest: t.rider.013
Friday at 4:13 PM
6.7 Tech
Tuning 101 - Thread Merged with Injector Posts
Latest: Charles
Friday at 5:10 AM
7.3 Aftermarket
B-Code VOP
Latest: Powerstroke Cowboy
Thursday at 9:15 AM
7.3 Aftermarket
9
20% TO 40% OFF ON FORD OEM PARTS
Latest: 99fordman18
Wednesday at 12:02 PM
Sunrise Ford Parts
Lower coil spring pad bolt
Latest: KBMKVIII
Tuesday at 7:14 AM
6.0 Tech
Members online
cmann250
Forums
Power Strokes
7.3 Tech
7.3 runs horrible after a decent drive.
Top