Reply to thread

Message: [QUOTE="hucorey, post: 939578, member: 13749"] You dont absolutely have to line bore but its the best way. You can remove all the main caps and have them milled down on the top side so they are all exact same height and surface grind or mill the bedplate straight instead of just taking them straight off the burn table. The main caps do indeed vary slightly in height. Use a known good machinist straight edge and feeler gauges and you'll see. If the caps are not exact same height then bolting the bedplate will distort the caps/bearings. [/QUOTE]

Verification

Random media

BW_362_sx-e_175-30_injectors

IMG-20111127-00002

IMG_20150521_105954279_HDR

BigOil_No_Lock1

eleanor_part_two_55_

2011-04-04_17-23-03_97

enhanced-buzz-32747-1336507828-2

Cfakepathimage11-14super-duty-cowl-hood01426173812

14 Dollar LED roll on Amazon

IMG_3094-1

Latest posts

02 F250 7.3 Will crank, WTS stays on, no start, no OBD
- Latest: Sterling6.7
- Sunday at 8:57 PM
7.3 Tech
P0087
- Latest: DEEZUZ
- Sunday at 11:49 AM
6.4 Tech & FAQ
2015-2019 6.7 HPFP New In Box
- Latest: lincolnlocker
- Jun 1, 2026
Engine and Drivetrain
First 6.0L (56k warning)
- Latest: adrianspeeder
- May 26, 2026
6.0 Tech
Extra external motor oil cooler?
- Latest: justinlogue5_0
- May 26, 2026
7.3 Tech

Members online

No members online now.

Total: 708 (members: 0, guests: 708)

Top